2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1780
* Fuel Pressure Sensor Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Pressure Sensor/Switch/Service and
Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for fuel pump control module replacement, setup,
and programming
P018D
DTC P018B-P018D
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC P018B
- Fuel Pressure Sensor Performance
DTC P018C
- Fuel Pressure Sensor Circuit Low Voltage
DTC P018D
- Fuel Pressure Sensor Circuit High Voltage
Diagnostic Fault Information
Circuit/System Description
The fuel pressure sensor is located on the fuel line. The fuel pressure sensor monitors the fuel pressure in the fuel line. The fuel pump flow control
module monitors the voltage signal from the fuel pressure sensor.
Conditions for Running the DTC
* The engine is running.
* DTC P018C, P018D, P0231, P0232, P023F, P064A, P1255 or P06A6 are not active.
* DTC P0641 has not failed this ignition cycle.
* Fuel pump control is enabled and the fuel pump control state is normal.
* The engine has been running for at least 5 seconds.
Conditions for Setting the DTC
The fuel pump control module does not detect a change in the fuel rail pressure of at least 30 kPa (4.4 psi) when the fuel pump is operating. The
fuel rail pressure sensor performance diagnostic provides a means to detect fuel pressure sensor output that is stuck within the normal operating
range of the sensor.
Action Taken When the DTC Sets
DTC P018B, P018C and P018D are Type A DTCs.
Conditions for Clearing the DTC
DTC P018B, P018C and P018D are Type A DTCs.
Diagnostic Aids
Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records
can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the
