2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1994
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.
Circuit/System Verification
Test for the correct operation of the IMS. Refer to Transmission Internal Mode Switch Logic (See: Specifications/Mechanical
Specifications/Automatic Transmission/Transaxle/System Specifications/2ML70 - Automatic Transmission/Transmission Internal Mode Switch
Logic).
If the IMS operation matches the IMS logic table, the system if functioning normally.
Circuit/System Testing
1. Disconnect the IMS harness connector at the control solenoid (w/body and TCM) valve assembly. Ignition ON. The scan tool IMS A/B/C/P
parameter should display HI for all 4 signal circuits.
锟斤拷If a signal circuit displays LOW, replace the control solenoid (w/body and TCM) valve assembly.
2. Connect a 3-amp fused jumper wire between each transmission range signal circuit at the control solenoid (w/body and TCM) valve assembly
and ground. With a scan tool, ensure that each signal circuit displays LOW when connected to ground.
锟斤拷If a signal circuit remains HI when connected to ground, replace the control solenoid (w/body and TCM) valve assembly.
3. Connect the IMS harness connector to the control solenoid (w/body and TCM) valve assembly. Disconnect the IMS connector. The scan tool
IMS A/B/C/P parameter should display HI for all 4 signal circuits.
锟斤拷If a signal circuit displays LOW, replace the IMS jumper harness.
4. Connect a 3-amp fused jumper wire between each transmission range signal circuit at the IMS connector harness and ground. With a scan
tool, ensure that each signal circuit displays LOW when connected to ground.
锟斤拷If a signal circuit remains HI when connected to ground, replace the IMS harness.
锟斤拷If a signal circuit other than the circuit being grounded displays LOW, replace the IMS harness.
锟斤拷If all circuits test normal, replace the IMS.
Component Testing
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Important: Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic
Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection) for the following components before replacing
