Friday, November 1, 2019

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1845

2010 Cadillac Truck Escalade ESV AWD V8-6.2L Page 1845

6. Ignition ON, test for 4.8-5.2 V between the MAF signal circuit terminal C and ground.

锟斤拷If less than the specified range, test the MAF signal circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace the ECM.

锟斤拷If greater than the specified range, test the MAF signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.

7. Ignition OFF, connect the red lead of the J 38522 to the MAF signal circuit terminal C at the MAF/IAT sensor harness connector. Connect

the battery voltage supply to B+, and the black lead to ground.

8. Set the J 38522 Signal switch to 5 V, the Frequency switch to 5K, and the Duty Cycle switch to Normal.

9. Engine idling, observe the scan tool MAF Sensor parameter. The scan tool MAF Sensor parameter should be between 4,950-5,050 Hz.

锟斤拷If not within the specified range, replace the ECM.

10. If all circuits test normal, test or replace the MAF/IAT sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Mass Airflow Sensor with Intake Air Temperature Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Air

Flow Meter/Sensor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup and programming

P0102

DTC P0102 or P0103

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0102

- Mass Air Flow (MAF) Sensor Circuit Low Frequency

DTC P0103

- Mass Air Flow (MAF) Sensor Circuit High Frequency

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The mass air flow (MAF) sensor is integrated with the intake air temperature (IAT) sensor. The MAF sensor is an air flow meter that measures the

amount of air entering the engine. The engine control module (ECM) uses the MAF sensor signal to provide the correct fuel delivery for all engine