2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 713
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Important: When using this diagnostic, more than one vehicle key is required to ensure proper diagnosis. If more than one key is not
available at the time of service, contact the customer and ask if any other keys can be provided for service. If unavailable, a new second
key can be created.
1. Perform the 10-Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (North America except Canada) (See: Accessories and
Optional Equipment/Antitheft and Alarm Systems/Service and Repair/Replacing Keys (North America Except Canada)).
2. While viewing the scan tool TDM Valid Key parameter, turn ON the ignition with each of the available vehicle keys. The parameter should
read Yes with all available keys.
瀚慖f not the specified value, replace the appropriate key.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Replacing Keys (North America except Canada) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and
Repair/Replacing Keys (North America Except Canada))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for TDM replacement, setup, and programming
B3105
DTC B3105
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3105
- Keyless Entry System Key Fobs Not Programmed
Circuit/System Description
The remote control door lock receiver (RCDLR) monitors the number of keyless entry transmitters programmed. Until at least one transmitter is
programmed, the RCDLR determines a malfunction condition exists.
Conditions for Running the DTC
The keyless entry system must be enabled.
Conditions for Setting the DTC
The DTC is set if there are no keyless entry transmitter programmed to the RCDLR.
Action Taken When the DTC Sets
The keyless entry system is inoperative.
