2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2639
DTC P2534
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC P2534
- Ignition 1 Switch Circuit Low Voltage
Diagnostic Fault Information
Circuit/System Description
The trailer brake control module monitors the ignition voltage circuit in order to determine if the voltage is within the normal operating range.
Conditions for Running the DTC
* Ignition ON.
* Battery voltage is 9.5-17 V.
* The module is powered up and completes initialization.
Conditions for Setting the DTC
The trailer brake control module detects that the ignition voltage is less than 6 V.
Action Taken When the DTC Sets
* The trailer brake control will be disabled for the remainder of the ignition cycle.
* The driver information center will display Service Trailer Brake System.
Conditions for Clearing the DTC
* The DTC will be current for as long as the fault is present.
* When the fault is no longer present, the DTC will be a history DTC.
* A history DTC will clear after 50 ignition cycles.
Reference Information
Schematic Reference
Trailer Brake Control Schematics (See: Brakes and Traction Control/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Trailer Brake Controls Description and Operation (See: Powertrain Management/Computers and Control Systems/Description and
Operation/Trailer Brake Controls Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
