2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 2641
* The TCM commands maximum line pressure.
* The TCM freezes transmission adaptive functions.
* The TCM commands the TCC OFF.
* The TCM allows the vehicle to operate in transmission protection mode.
* The TCM disables Tap up and Tap down functions.
Conditions for Clearing the DTC
DTC P2534 is a Type A DTC.
Diagnostic Aids
If all circuit tests are OK, ensure the transmission pass through connector and harness terminals are clean and not damaged, and the charging
system is functioning correctly.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Description and Operation
* Transmission General Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Transmission General Description)
* Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and
Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Transmission Component and System Description)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
(DTC) Type Definitions)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Verification
1. Engine ON, accessories OFF, measure and record the battery voltage with a DMM. The battery voltage should be between 12.5-14.5 volts.
瀚慖f the voltage is not within the specified value, or the charge indicator light is ON, refer to Symptoms - Engine Electrical (See: Starting
and Charging/Testing and Inspection/Symptom Related Diagnostic Procedures/Symptoms - Engine Electrical).
2. Observe the scan tool TCM Ignition Voltage parameter. The reading should be between 12.5-14.5 volts.
3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the
conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
1. Ignition OFF, disconnect the X1 16-way harness connector at the T12 automatic transmission assembly.
2. Ignition OFF, test for less than 5 ohms on the vehicle harness connector X1 terminal 5 and ground at the transmission case.
瀚慖f greater than then specified valve, test the ground circuit for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates at connector X1 vehicle harness side and the following terminals:
* Terminal 4 and ground at the transmission case
* Terminal 12 and ground at the transmission case
