2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 708
* Remote start functions will be disabled.
* The hood ajar switch inputs will be ignored by content theft deterrent (CTD).
Conditions for Clearing the DTC
* A current DTC will clear when the conditions for setting are no longer present.
* A history DTC will clear after 40 malfunction free ignition cycles.
Reference Information
Schematic Reference
* Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical
Diagrams/Immobilizer Schematics)
* Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry
Transmitter/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Keyless Entry System Description and Operation (Without Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and
Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (Without Accessory 2 Way Remote)
)Keyless Entry System Description and Operation (With Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and
Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (With Accessory 2 Way Remote))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, observe the scan tool BCM Hood Open Switch and Hood Closed Switch parameters. With the hood open, the Hood Open Switch
parameter should read Active and the Hood Closed Switch parameter should read Inactive. With the hood closed, the Hood Open Switch parameter
should read Inactive and the Hood Closed Switch parameter should read Active.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the hood ajar switch.
2. Ignition OFF, test for less than 5 ohms between the ground circuit terminal C and ground.
瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, test for 11.5-12.0 volts between the signal circuit terminal A and ground.
瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the BCM.
4. Ignition ON, test for 11.5-12.0 volts between the signal circuit terminal B and ground.
瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the BCM.
5. If all circuits test normal, test or replace the hood ajar switch.
