Friday, November 1, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1856

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1856

5. Install a 3A fused jumper wire between the signal circuit and the 5-volt reference circuit. Verify the scan tool MAP Sensor parameter is

greater than 103 kPa.

瀚慖f less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the ECM.

6. If all circuits test normal, test or replace the MAP sensor.

Component Testing

Important: You must perform the Circuit/System Testing in order to verify the integrity of the MAP sensor circuits before proceeding

with the Component Testing.

1. Turn ON the ignition, with the engine OFF, and remove the MAP sensor.

2. Install a 3A fused jumper wire between the 5-volt reference circuit and the corresponding terminal of the MAP sensor.

3. Install a jumper wire between the low reference circuit of the MAP sensor and ground.

4. Install a jumper wire at the MAP sensor signal circuit.

5. Connect a DMM between the jumper wire from the MAP sensor signal circuit and ground.

6. Install the J-35555 to the MAP sensor vacuum port. Slowly apply vacuum to the sensor while observing the voltage on the DMM. The

voltage should vary between 0-5.2 volts without any spikes or dropouts.

瀚慖f the voltage is not within the specified range or is erratic, replace the MAP sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Manifold Absolute Pressure Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Manifold

Pressure/Vacuum Sensor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming

P0108

DTC P0107 or P0108

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0107

- Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage

DTC P0108

- Manifold Absolute Pressure (MAP) Sensor Circuit High Voltage

Diagnostic Fault Information

Typical Scan Tool Data