2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 373
DTC B1000 F0
- Side Object Detection RF Transmit Chain Failed
DTC B1000 F1
- Side Object Detection RF Receive Chain Failed
DTC B1000 F2
- Side Object Detection Frequency Calibration Failure
DTC B1000 F3
- Side Object Detection Inter-Processor Communication Failed
Circuit/System Description
The internal fault detection is handled inside the control module. No external circuits are involved.
Conditions for Running the DTC
The module runs the program to detect an internal fault when power up is commanded. The only requirements are voltage and ground. This
program runs even if the voltage is out of the valid operating range.
Conditions for Setting the DTC
The module has detected an internal malfunction.
Action Taken When the DTC Sets
The module refuses all additional inputs.
Conditions for Clearing the DTC
* A current DTC clears when the malfunction is no longer present.
* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 100, without a repeat of the malfunction.
Diagnostic Aids
* This DTC may be stored as a history DTC without affecting the operation of the control module.
* Do not replace a control module based only on DTC B1000 being set in history with the exception of the following control modules:
- Sensing and Diagnostic Module (SDM)
- Rollover Sensor
- Passenger Presence System Module
* If DTC B1000 is set as current, replace the appropriate control module.
Circuit/System Verification
If the DTC is set, replace the appropriate control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.
Control Module References (See: Testing and Inspection/Programming and Relearning) for module replacement, setup, and programming
Data Communications
DTC B1001
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
