Wednesday, December 18, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 97

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 97

瀚慖f greater than the specified range, test the circuit for a short to voltage.

13. Ignition OFF, test for infinite resistance between the high circuit terminals listed below and ground.

* Driver steering wheel air bag coil connector Stage 1 terminal A X1

* Driver steering wheel air bag coil connector Stage 2 terminal A X2

瀚慖f less than the specified value, test the circuit for a short to ground.

14. Test for infinite resistance between the low circuit terminals listed below and ground.

* Driver steering wheel air bag coil connector Stage 1 terminal B X1

* Driver steering wheel air bag coil connector Stage 2 terminal B X2

瀚慖f less than the specified value, test the circuit for a short to ground.

15. Test for less then 1 ohm between the SDM connector and the air bag connector high circuit terminals listed below.

* Driver steering wheel air bag coil connector Stage 1 terminal A X1 and SDM terminal 4 X1.

* Driver steering wheel air bag coil connector Stage 2 terminal A X2 and SDM terminal 1 X1.

瀚慖f greater than the specified range, test the circuit for an open/high resistance.

16. Test for less then 1 ohm between the SDM connector and the air bag connector low circuit terminals listed below.

* Driver steering wheel air bag coil connector Stage 1 terminal B X1 and SDM terminal 3 X1

* Driver steering wheel air bag coil connector Stage 2 terminal B X2 and SDM terminal 2 X1

瀚慖f greater than the specified range, test the circuit for an open/high resistance.

17. If all circuits test normal, replace the SDM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Steering Wheel Inflatable Restraint Module Coil Replacement (See: Restraints and Safety Systems/Air Bag Systems/Clockspring Assembly

/ Spiral Cable/Service and Repair/Removal and Replacement)

* Steering Wheel Inflatable Restraint Module Replacement (See: Restraints and Safety Systems/Air Bag Systems/Air Bag/Service and

Repair/Removal and Replacement/Steering Wheel Inflatable Restraint Module Replacement)

* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Wiring Repairs/SIR/SRS Wiring Repairs)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming

B0014

DTC B0014-B0045

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B0014 01

- Driver Side Seat Air Bag Deployment Loop Short to Battery

DTC B0014 02

- Driver Side Seat Air Bag Deployment Loop Short to Ground

DTC B0014 04

- Driver Side Seat Air Bag Deployment Loop Open Circuit