2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 177
-The ignition is ON.
-Ignition voltage is between 9-16 volts.
-The assist step disable switch is not pressed.
Conditions for Setting the DTC
B051A 0B, B051B 0B
The motor control circuits are shorted together.
B051A 01, B051B 01
A motor control circuit is shorted to battery voltage.
B051A 02, B051B 02
A motor control circuit is shorted to ground.
B051A 04, B051B 04
A motor control circuit is open.
B051C 01
The hall sensor 10 V reference is shorted to battery voltage.
B051C 02
The hall sensor 10 V reference is shorted to ground.
B051C 2A, B051D 2A
The hall sensor counts are greater than what is required to extend or stow the running board.
B051C 22, B051D 22
The hall sensor signal is noisy.
B051C 29, B051D 29
No hall sensor counts are detected while the motor is active.
B051C 62, B051D 62
The running board stow time is greater than 4 seconds.
B051C 63, B051D 63
The running board extend time is greater than 4 seconds.
Action Taken When the DTC Sets
Driver A and driver B circuits are deactivated for the appropriate actuator.
Conditions for Clearing the DTC
-The DTC becomes history when the Assist Step Control Module no longer detects the condition that set the DTC.
-The history DTC will clear after 50 fault free ignition cycles.
Reference Information
Schematic Reference
Step/Running Board Schematics
Connector End View Reference
